Select your region above
We'll show the typical day rate, hourly rate, and how your region compares nationally.
Day rates (8-hour day, labour only)
Minimum
—
per day
Typical
Day Rate
—
per day
Maximum
—
per day
Hourly rates (day rate ÷ 8)
Minimum
—
per hour
Typical
Typical
—
per hour
Maximum
—
per hour
All regions
| Region | Min / day | Typical / day | Max / day |
|---|
Important: Rates are indicative benchmarks only. Always obtain at least three quotes before commissioning work. Figures are for labour only, excluding materials, VAT, and call-out charges.
About these figures
Day rates are for self-employed tradespeople working an 8-hour day, labour only. Hourly rates are calculated as day rate ÷ 8. Benchmarked against Checkatrade and UK industry surveys, updated April 2026.
Why rates vary by region
Cost of living, demand, and local competition all affect day rates. London and the South East typically run 30–45% above the national midpoint. The North East, Wales, and Northern Ireland sit 15–20% below.
How to use this data
Use these figures to sense-check quotes — not as a fixed price. Experience, accreditations, and job complexity all affect pricing. Always get at least three written quotes before committing to any work.
Tiler day rate — frequently asked questions
Tiler day rates range from around £155/day in Northern Ireland to £480/day in London. The national typical is around £225–£275/day. Complex work such as large-format tiles, herringbone patterns, or wet room installation commands higher rates.
Tiling an average bathroom (around 5–6m²) takes 1–3 days depending on complexity. At typical day rates, labour runs £300–£800 excluding tiles. Large-format or designer tiles require more skill and time, increasing the labour cost.
On standard wall tiles, an experienced tiler can lay 8–12m² per day. Floor tiles take longer, particularly if levelling compound or underfloor heating is involved. Large-format tiles (600x600mm+) are slower to lay correctly.
Buying your own tiles gives you full control over cost and choice. Tilers sourcing tiles will typically add a 10–15% markup. If you buy your own, buy at least 10% extra to allow for cuts and breakages.
Floor tiles must be rated for floor use (slip resistance and load bearing). Wall tiles can be lighter and thinner. Using wall tiles on a floor is a common mistake that leads to cracking. A good tiler will advise you on the correct specification.